|
|
7 k2 Q7 e" }- D: _
包括pads帮助文档里写的也很简单：! T- C3 A6 s' k I: ~) ]* G
To copy and paste a route:
8 y# A8 a x, |+ x1. Select a segment or pin pair.
& j9 M/ F" C0 O8 H0 a7 x3 f2. Click Copy from the Edit menu, or press Ctrl+C. All included segments and vias are
! x, d7 N7 O; `$ Aanimated, or copied and attached to your pointer in Move mode.
$ o* L; b2 r* T3. If necessary, use the shortcut menu commands to rotate or flip the copy.2 t# S0 W& h, e) u# [" |- s N! _* `1 m3 h
4. Indicate the location so it joins the pins to which you want to paste. A copy is pasted and% B! D# v. X+ G
another copy remains attached to the pointer so you can paste it again.
, l/ }& T; Z4 lThe pointer then snaps automatically to a point the same distance from and in the same
# q \( O, i% Y( M* ndirection as the last placement. This makes it easy to install repetitive route patterns.
0 P0 `1 \' a, y, \8 L1 ^' i/ _5. Press Esc to cancel further copies.0 o3 L7 s; V7 R$ r) Y" b
A copied trace only pastes to a valid electrical connection: you cannot paste to empty space. If
; f5 H7 N, |5 R9 H& _. a: p, rthe copied traces are shorter than the target pin pair, a connection is created from the end of the
" T9 t- F, v. |* D! Ucopy to the other pin of the pair.
' m9 z, s1 l( }" r8 T2 ?/ f但是问题是死活复制不上，是怎么回事呢？
+ E% _) S G8 U! _4 d如附件图片所示，我想把板子上部那些较粗的线在底层也布一遍，以增加通过电流的能力，但是就是黏贴不上。
/ W i0 W/ F) |5 ?& a如果单选一条线，有时可以，有时就不行，不知道问题出在哪里？( Z) Y4 |4 @+ Q, v- T- k2 | f
我用的是pads9.3
# ]6 j: p* D8 k O5 w/ I谢谢！ |
|
/1 
发表于 2014-5-13 12:53
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主