|
|
0 m, k& `, K1 A. S$ \" U% O包括pads帮助文档里写的也很简单： N5 x# V7 G9 n% `
To copy and paste a route:
v1 d% k2 N3 B5 ]7 v7 f1. Select a segment or pin pair.$ o: r o' k5 u' w
2. Click Copy from the Edit menu, or press Ctrl+C. All included segments and vias are Q, E B1 v% S
animated, or copied and attached to your pointer in Move mode.
# K7 {2 u' o7 m1 }( Q- `3. If necessary, use the shortcut menu commands to rotate or flip the copy.0 u7 o& t0 [4 w/ @- f# I
4. Indicate the location so it joins the pins to which you want to paste. A copy is pasted and; \) q* ^ c% ]
another copy remains attached to the pointer so you can paste it again., f% y v5 `6 o8 h3 ?3 v5 X4 E
The pointer then snaps automatically to a point the same distance from and in the same
# y: d! f+ s3 ?( F+ wdirection as the last placement. This makes it easy to install repetitive route patterns.. H$ w" z4 b& o, ?4 V; i
5. Press Esc to cancel further copies.
0 T. {8 ^$ i: D0 u9 sA copied trace only pastes to a valid electrical connection: you cannot paste to empty space. If/ H! O" D, b' P, a* I
the copied traces are shorter than the target pin pair, a connection is created from the end of the
/ f3 ]3 L' V% k; R/ G3 O9 p8 W) Lcopy to the other pin of the pair.
% G- a6 j4 F+ L d2 S但是问题是死活复制不上，是怎么回事呢？
- A: a. |1 a6 |( l7 v* n E4 o9 Z如附件图片所示，我想把板子上部那些较粗的线在底层也布一遍，以增加通过电流的能力，但是就是黏贴不上。+ T# i, u+ p6 ^7 M- m, `" `- J1 N
如果单选一条线，有时可以，有时就不行，不知道问题出在哪里？
2 Z# G% Z5 M* W) b5 ]1 m* a7 f, C. s我用的是pads9.33 D X7 u; b! p/ r8 i' d" _; W
谢谢！ |
|
/1 
发表于 2014-5-13 12:53
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主