光绘出问题了！！！！

buptdlmuzbx

9 r4 r9 u- @$ e- d$ ?: w$ i
! l# a  p) x: }& NSUMMARY:
        TOP created with warnings
$ W- h% V0 b6 T9 R        GND created with warnings
6 t8 d) E0 F" z: {# o. u, O( E7 _7 D        VCC created with warnings
        BOTTOM created.
        SILKSCREEN_TOP created with warnings
        SILKSCREEN_BOTTOM created.
( Y$ k+ }  e3 F. M. ^        SOLDERMASK_TOP created.
        SOLDERMASK_BOTTOM created.
' e" e* m3 x0 i. Y' Z6 @' L/ _        PASTEMASK_TOP created.
* [4 T7 m3 l. K$ y2 E4 M( [        PASTEMASK_BOTTOM created.
0 c' W! Q  b4 O& `( M        OUTLINE created.
        DRILL created.
' w) Z0 _9 p- b% g% F ARTWORK finished
这是最后的结果，
  M: |! E2 e# A1 D! n我想问下既然光绘finished，那这些warning能忽略吗？
6 }, i0 m2 r5 y/ z8 F2 s& CWARNING: 0 width line found at (0.0000 0.6350)
           ... using undefined line width of 0.1524
WARNING: Multiple 0 width lines; all will be treated the same as the first.
           ... using undefined line width of 0.1524
* u! D. T' S0 p3 x* v    WARNING: No Photoplot Outline was found,
negative shape outline will be determined by Board Outline
WARNING: No Photoplot Outline was found,
negative shape outline will be determined by Board Outline
! I0 t/ h* ]' E( q- ^5 aWARNING: text composed 0 width line found at (9.7282 5.5626)
8 x. t& h; s" Y9 V           ... using undefined line width of 0.1524
    WARNING: text having Multiple 0 width lines; all will be treated the same as the first.
           ... using undefined line width of 0.1524

" J7 b) f" w& f4 @  q9 \/ l# X
; @" _. P& ]0 N6 }' ]这是什么呀！谁能给解决下！有木有！有木有！
8 V+ w: M" P/ o

penny190

請問您是不是有SHAPE做的零件超出板框了呢？

neg

artwork中将每层的undefined  line  width不要设置为零

leavic

可以，我经常碰到这种未定义线宽的warning，只要自己定义了undefiend line width就可以。
9 f3 ~) A5 B! n奇怪的是有些板子会报这种warning，有些就完全不会，虽然都有未定义线宽的trace。