求助，CAPTURE CIS生成网表导入allegro时出错

wang354298

我用的是16.2的版本，用CAPTURE CIS生成了网络表，三个文件都产生了，但是导入allegro时就报以下警告，没有错误但是还是导不进元件，这是怎么会事？请高手帮忙解决，谢谢！
#1   WARNING(SPMHNI-192): Device/Symbol check warning detected.
WARNING(SPMHNI-337): Unable to load symbol 'SIP_2P' for device 'ANT920_1_SIP_2P_ANT920': WARNING(SPMHUT-127): Could not find padstack PAD41.
7 o+ B6 N: K. U* C2 y8 q    due to ERROR(SPMHDB-274): Unable to load flash symbol PAD41 (Check PSMPATH setting for this symbol).
#2   WARNING(SPMHNI-192): Device/Symbol check warning detected.
( F# Y/ m2 W' b1 K% l0 y: KWARNING(SPMHNI-337): Unable to load symbol '0805' for device 'CAP NP_0805_104': WARNING(SPMHUT-127): Could not find padstack PAD14.
- K: k; {1 z; p( \2 J) o    due to ERROR(SPMHDB-274): Unable to load flash symbol PAD14 (Check PSMPATH setting for this symbol).
#3   WARNING(SPMHNI-192): Device/Symbol check warning detected.
WARNING(SPMHNI-337): Unable to load symbol '0805' for device 'CAP NP_0805_472': WARNING(SPMHUT-127): Could not find padstack PAD14.
) i# o: M5 h: P1 Q2 W    due to ERROR(SPMHDB-274): Unable to load flash symbol PAD14 (Check PSMPATH setting for this symbol).
#4   WARNING(SPMHNI-192): Device/Symbol check warning detected.
WARNING(SPMHNI-337): Unable to load symbol '0805' for device 'CAP NP_0805_332': WARNING(SPMHUT-127): Could not find padstack PAD14.
5 d4 [3 C1 Z4 s$ ]" f    due to ERROR(SPMHDB-274): Unable to load flash symbol PAD14 (Check PSMPATH setting for this symbol).
#5   WARNING(SPMHNI-192): Device/Symbol check warning detected.
. J3 |  U* k1 \3 _4 D% P  [& m: M7 I- DWARNING(SPMHNI-337): Unable to load symbol '0805' for device 'CAP NP_0805_100P': WARNING(SPMHUT-127): Could not find padstack PAD14.
    due to ERROR(SPMHDB-274): Unable to load flash symbol PAD14 (Check PSMPATH setting for this symbol).

5 w" L; b- N( b: N( H/ r  [8 h! _

flysky

你的库里没有相应的pad

dsws

检查库，核定设计路径

yujian

:):):):)

zslic78

焊盘路径不对的

clp783

我的也老是遇到错

wang354298

谢谢，我找到错误的地方了，是我这个元件没有对应的封装。

mengshang

焊盘的问他，热风焊盘找不到