IC模型的问题

hnushixueqian

在仿真时怎么添加IC模型，我是从pads layout里面导入到hyperlynx里面的，仿真的时候提示说没有IC模型，我想知道怎么添加。好像可以在导入之前添加，怎么做？希望各位指教
  _4 I  Q9 _8 H  vNET INFORMATION
, f* _# k. S+ N$ C( w2 n9 d2 B**********************************************************************
/ J. p# N- b8 J5 _6 `8 K  NET = SD8, D8
     ** Warning(Severe) ** Missing IC model(s); unable to simulate
% g# z4 ?3 w; C" K$ c     ** Warning(Severe) **
  NET = D10, SD10
' f4 O+ o( j# \2 e  c# z- s/ s     ** Warning(Severe) ** Missing IC model(s); unable to simulate
% l% X# @- U) N5 H3 f     ** Warning(Severe) **
6 W5 Y7 e% I; d- f0 @  NET = D11, SD11
     ** Warning(Severe) ** Missing IC model(s); unable to simulate
1 o' \) l) C; E' L# ]2 h3 p     ** Warning(Severe) **
  NET = D15, SD15
4 W: g7 c" {9 u. w# J! v     ** Warning(Severe) ** Missing IC model(s); unable to simulate
     ** Warning(Severe) **
8 m& {- _. G, V* M, `  NET = D9, SD9
; }; |- n5 ^6 a+ o- q     ** Warning(Severe) ** Missing IC model(s); unable to simulate
     ** Warning(Severe) **
  NET = D13, SD13
     ** Warning(Severe) ** Missing IC model(s); unable to simulate
( R2 \: O, ?2 W: \6 a     ** Warning(Severe) **
; k% M! D9 N8 O# R! c9 i5 D1 j& {  NET = D12, SD12
/ ?8 P0 f5 U9 t     ** Warning(Severe) ** Missing IC model(s); unable to simulate
     ** Warning(Severe) **
# k% W/ x1 E5 R* m  NET = SD14, D14
1 g1 l! Q4 [( O- _     ** Warning(Severe) ** Missing IC model(s); unable to simulate
+ a; v5 l& |0 }7 I, \! C     ** Warning(Severe) **

suven

在Edit 下的REF IC Automapping 那里，找到对应的模型点paste Models 就行了！！