cr5000 v15.0 请教大神一个相同模块配置配线的问题！！！

wx_CX70Wp0t

cr5000 v15.0 这个功能怎么用啊？（相同模块配置配线用）12个相同的模块，为什么出来的情报中有的模块中器件没有按照规律排列？这个功能要和原理图联动？请大神帮忙！！跪谢！！
- [0 @+ l6 V) I
4 j0 D! x0 v, }

wx_CX70Wp0t

没有大神吗？

chenxztiger

没有看到你12模块具体的情况，不好说。
- }" L& k& ?* y  e( a$ r& ^从你的图看，12个模块已经OK啦。其它的可能不符合条件，请参考Help：
  C; Q( Y3 J, G% [2    The target components of copy destination must satisfy the following conditions:
3 n& Q" x# r) e) f4 \
9 X$ U# a! x: N3 b- Rn     An unplaced component or off-board component

n     A component having the same part name as that of an original component

n     A component having the same pin connection as that of an original component

n     A component without position lock.

n     When a component is locked in angle, its angle is the same as that of the original one.

n     When a component is locked in placement, its placement side is the same as that of the original one.
! q$ L: \  o0 m; j; t" W( S. i
, E! H3 ~" f1 m" Q3    The original figures to be copied must satisfy the following conditions:
5 L6 U# o1 t6 J8 s, l7 f3 {$ g7 [4 N
n     A figure on the layer which is set to visible.
' a9 P0 `2 x# c5 r8 E) t2 U; z" o
n     A figure on the active layer when Reference Active Layer is set to on.
; f* _$ x" w, r/ C, Z3 J9 U
4 M4 x/ I2 d4 q2 |n     For vias, any layer among from-layer and to-layer of the via is the selected layer.

FeniX0419

用日语版。。同学不错啊

weigz

谢谢分享

419549254

这个功能就是这样，有些识别不了，不是很好用