关于设置走线宽度的宏命令问题

小小黄三

在ROUTER中我想录制几个走线线宽的宏设置，好比我设置数字键4 5 6对应的线宽分别为0.1MM  0.2MM  0.3MM。
, |5 ?: D2 n& |; i我是这样录制作的，开始按F3，然后按W 设置线宽为0.2MM，
8 z8 E0 `# T. d5 G& k, }点结束，出来的宏语法为

+ o" O5 u; y' F# H+ ^1 gApplication.ExecuteCommand("Interactive Route", 69.6937733mm, -53.3785367mm)
Application.ExecuteCommand("Select", 68.9406267mm, -53.5396147mm)
# z6 i, @6 h+ G& g5 N5 L6 l, F6 RApplication.ExecuteCommand("Set Width", "0.2")
3 G( C& ^8 t& O; K. t, |Application.ExecuteCommand("End Routing")
/ G9 @/ B" h5 m9 g$ o# W9 \然后我删掉了一些无用的，最后的结束也删除了，
设置了5为快捷，但是现在按5出来的还是0.1MM的线宽，
不知道问题出在哪，

jimmy

Application.ExecuteCommand("Add Route")
Application.ModelessCommand("w")DlgModelessCmd.Command = "w "
DlgModelessCmd.Command = "w 0.1mm"
DlgModelessCmd.OnOk()

jimmy

Application.ExecuteCommand("Add Route")
9 p% F. q/ O4 oApplication.ModelessCommand("w")DlgModelessCmd.Command = "w "
2 _) E: E! S' R; D% A# [  Y+ xDlgModelessCmd.Command = "w 0.2mm"
! L7 @4 V) b! j1 ^8 @+ ~; bDlgModelessCmd.OnOk()

jimmy

Application.ExecuteCommand("Add Route")
/ v  o% O% J5 y/ l! S6 n( @! I4 DApplication.ModelessCommand("w")DlgModelessCmd.Command = "w "
7 m; m' h, e4 _% G' F9 SDlgModelessCmd.Command = "w 0.3mm"
DlgModelessCmd.OnOk()