关于设置走线宽度的宏命令问题

小小黄三

在ROUTER中我想录制几个走线线宽的宏设置，好比我设置数字键4 5 6对应的线宽分别为0.1MM  0.2MM  0.3MM。
我是这样录制作的，开始按F3，然后按W 设置线宽为0.2MM，
# H7 u/ W$ q7 r0 F点结束，出来的宏语法为

Application.ExecuteCommand("Interactive Route", 69.6937733mm, -53.3785367mm)
$ k4 a% X) h' X4 OApplication.ExecuteCommand("Select", 68.9406267mm, -53.5396147mm)
: P3 y2 h! @0 a& ?Application.ExecuteCommand("Set Width", "0.2")
Application.ExecuteCommand("End Routing")
然后我删掉了一些无用的，最后的结束也删除了，
设置了5为快捷，但是现在按5出来的还是0.1MM的线宽，
2 P8 V$ R$ u3 n+ x! [9 O不知道问题出在哪，

jimmy

Application.ExecuteCommand("Add Route")
+ z6 d1 P' |4 p1 O; A- @Application.ModelessCommand("w")DlgModelessCmd.Command = "w "
DlgModelessCmd.Command = "w 0.1mm"
- U5 B. U% c* N8 oDlgModelessCmd.OnOk()

jimmy

Application.ExecuteCommand("Add Route")
, L% L/ L5 p7 `! b$ A: O# EApplication.ModelessCommand("w")DlgModelessCmd.Command = "w "
DlgModelessCmd.Command = "w 0.2mm"
: z+ l+ p0 G6 |! SDlgModelessCmd.OnOk()

jimmy

Application.ExecuteCommand("Add Route")
Application.ModelessCommand("w")DlgModelessCmd.Command = "w "
- a* q2 O; y/ B& IDlgModelessCmd.Command = "w 0.3mm"
DlgModelessCmd.OnOk()