IC模型的问题

hnushixueqian

在仿真时怎么添加IC模型，我是从pads layout里面导入到hyperlynx里面的，仿真的时候提示说没有IC模型，我想知道怎么添加。好像可以在导入之前添加，怎么做？希望各位指教
5 c" r3 \6 l) |$ F0 F9 a( k- RNET INFORMATION
3 }/ x1 |5 n! q' H5 d+ w2 `**********************************************************************
  NET = SD8, D8
     ** Warning(Severe) ** Missing IC model(s); unable to simulate
, s. H7 \! p' Q% Z     ** Warning(Severe) **
) ?# n6 h2 |9 }' f9 r  NET = D10, SD10
% u! n7 C7 N% q! Q3 b) R- ]$ Z( m  F# C     ** Warning(Severe) ** Missing IC model(s); unable to simulate
; Q3 Y. {( p; J- R% ^     ** Warning(Severe) **
+ f# l2 g+ R" E- |9 o: t7 c  NET = D11, SD11
0 Q) e# }0 w. e9 J     ** Warning(Severe) ** Missing IC model(s); unable to simulate
  Z1 M( B' V' q; ?& n     ** Warning(Severe) **
, Z9 Z  X9 C2 E, k' k  c  NET = D15, SD15
     ** Warning(Severe) ** Missing IC model(s); unable to simulate
     ** Warning(Severe) **
* z' c; n8 H" ^) L* P  NET = D9, SD9
3 g# r. q. p1 _2 U6 l     ** Warning(Severe) ** Missing IC model(s); unable to simulate
     ** Warning(Severe) **
; C- Q# }( G3 u' ?2 e! f  NET = D13, SD13
3 }& U6 c$ B, u2 P  t     ** Warning(Severe) ** Missing IC model(s); unable to simulate
     ** Warning(Severe) **
  NET = D12, SD12
, B$ i; C7 ?, u3 U* t7 g     ** Warning(Severe) ** Missing IC model(s); unable to simulate
( ?, c/ ^* ?6 U+ ]  ~# q3 e     ** Warning(Severe) **
  NET = SD14, D14
( ~/ N) C( Z1 t6 R5 e5 \( \0 M     ** Warning(Severe) ** Missing IC model(s); unable to simulate
4 ]/ d: f/ Q. f! l& H! c     ** Warning(Severe) **

suven

在Edit 下的REF IC Automapping 那里，找到对应的模型点paste Models 就行了！！