|
|
本帖最后由 超級狗 于 2014-2-24 08:33 编辑 + S0 i$ J# U5 f' z/ T$ o
H* o) g( A; Y- t; o- \ c; n6 u
因為您沒講得很清楚是訊號端（LVDS Side）或邏輯端（Logic Side）的輸入。
2 O& Z5 Y& T( v9 ]; P$ g" G, K( T" r# Y
- 訊號輸入（LVDS Input）建議懸空（Floating），除非芯片資料有特別指示。
- 邏輯輸入（Logoc Input）建議上拉至邏輯電源（VDD），或是下拉至地（GND），除非芯片資料有特別指示。/ H* S/ o" b/ g8 Y! R% J; B
& M1 a. h* \0 V9 `2 ?! D/ O2 T6 R% H1 j
! {% ~1 ]1 [7 u! }% E) RUnused pins) @ o/ ~( h O; X J
" m- z5 D: z5 RLVDS inputs - Leave unused LVDS receiver inputs open (floating) for LVDS receivers unless directed differently by the specific component’s datasheet. Their internal failsafe feature will provide sufficient biasing to put the outputs in a known state. These unused receiver inputs should not be connected to noise sources such as cables or long PCB traces - float them near the pin. LVDS receivers are high-speed, high-gain devices, and only a small amount of noise, if picked up differentially will cause the receiver to respond. This causes false transitions on the output and increases power consumption.
( M( L# w) S! p
7 I! k: Z; E: u; B! T, qLVDS and TTL outputs - Leave all unused LVDS and TTL outputs open (floating) to conserve power.Do not tie them to ground.
8 B, X1 u0 h5 L- G6 {
k5 G7 p- P( \. s" A+ I2 [TTL inputs - Tie unused TTL transmitter/driver inputs and control/enable signals to power or ground or in certain cases they may be left open if the datasheet supports this condition. Some devices provide internal pull down (or up) devices to bias the pins. Again, consult the datasheet for information regarding the device’s features. This type of information is typically included in the pin description table.% z% q; _0 [, G; l7 X
9 i9 X( Z0 ~1 r, t6 k7 y5 w4 n
 |
|
/1 
发表于 2014-1-2 16:56
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
发表于 2014-2-24 08:29
