|
|
没有看到你12模块具体的情况，不好说。, i6 I; B, N# P# i; D
从你的图看，12个模块已经OK啦。其它的可能不符合条件，请参考Help：
, E9 n' Y, E$ R* f" J2 The target components of copy destination must satisfy the following conditions:
$ ~4 O( W% A" H
7 _ s! O6 `) v* hn An unplaced component or off-board component! b% G' B# U: W9 j6 m- ?
: b( b7 S3 w1 W* b7 R$ ^0 d
n A component having the same part name as that of an original component
$ `9 C; ^* I0 e
. k8 e& l( q: j, ~ B4 b" Wn A component having the same pin connection as that of an original component
1 E4 S$ C+ j; q3 c/ ]1 }5 W) u; P
5 n/ ^3 J, @, x+ F% in A component without position lock.
4 ~+ e* M1 Z9 r: ^0 k( z; _$ I! Y
: Y7 x: ?0 ] ^: O. \n When a component is locked in angle, its angle is the same as that of the original one.7 ?4 p6 G1 J2 N! b0 f' J
! R& V7 G4 l' b. ^0 ?( u
n When a component is locked in placement, its placement side is the same as that of the original one.
) \+ }0 M) i; _' Q" \8 e; |& D: S. X% H, R
3 The original figures to be copied must satisfy the following conditions:
2 ]/ m5 s+ `7 r5 w' l- x; \
- z) I% y8 |& O' s8 ^n A figure on the layer which is set to visible.! ^2 g! ^" N$ P/ Q
4 d1 B2 A; F& p. T5 `
n A figure on the active layer when Reference Active Layer is set to on.
1 d+ a6 a" }& b! D0 O
Q% B! S4 ~& yn For vias, any layer among from-layer and to-layer of the via is the selected layer.
/ b4 b7 J1 R4 `; G7 @ |
|
/1 
发表于 2017-5-31 16:59
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主
发表于 2017-8-6 07:28
