cr5000 v15.0 请教大神一个相同模块配置配线的问题！！！

wx_CX70Wp0t

cr5000 v15.0 这个功能怎么用啊？（相同模块配置配线用）12个相同的模块，为什么出来的情报中有的模块中器件没有按照规律排列？这个功能要和原理图联动？请大神帮忙！！跪谢！！

+ o/ }) J4 k& s6 I0 u

wx_CX70Wp0t

没有大神吗？

chenxztiger

没有看到你12模块具体的情况，不好说。
从你的图看，12个模块已经OK啦。其它的可能不符合条件，请参考Help：
2    The target components of copy destination must satisfy the following conditions:
8 P$ ~: l- t% e) E' d% b3 o
! l7 D3 }* w- d0 C& Z( jn     An unplaced component or off-board component
- o" g+ e& K2 G0 \* T9 _6 [
, P/ x3 S" t% o8 `n     A component having the same part name as that of an original component

) c' g+ v( }" G. \9 [1 xn     A component having the same pin connection as that of an original component

n     A component without position lock.
5 l4 ?+ a' j) B  H# E/ r2 w) R
8 a# m6 Y5 v# i4 r$ z1 An     When a component is locked in angle, its angle is the same as that of the original one.
7 e: b/ `9 s% h2 Y) G. M, e
n     When a component is locked in placement, its placement side is the same as that of the original one.

6 w0 z" c; p9 H1 r* l3    The original figures to be copied must satisfy the following conditions:

. e2 F: }, P, C1 x2 \: e# K) bn     A figure on the layer which is set to visible.
& E- _! ^4 J+ W; {; P% Q! _- N
% b. `- M) e4 d* Y+ k. X! l+ On     A figure on the active layer when Reference Active Layer is set to on.
, b1 n0 u) _) ]! U% r
% k' M! {, N) X/ k  ^6 Un     For vias, any layer among from-layer and to-layer of the via is the selected layer.

FeniX0419

用日语版。。同学不错啊
" W& c4 C$ U* R  I

weigz

谢谢分享

419549254

这个功能就是这样，有些识别不了，不是很好用