|
陰特兒(Intel)1000Base-T 設計指導書(Design Guide):
8 U9 v% Y' F$ g! t) {7 b: U( J- v" w: C2 n/ {( k, B
Magnetics modules for 1000 BASE-T Ethernet are similar to those designed solely for 10/100 Mbps, except that there are four differential signal pairs instead of two. Use the following guidelines to verify specific electrical parameters: P* r, g$ U, @" c
- Verify that the rated return loss is 19 dB or greater from 2 MHz through 30 MHz for 100BASE-TX.
- Verify that the rated return loss is 12 dB or greater at 80 MHz for 100 BASE-TX (the
- specification requires greater than or equal to 10 dB). Verify that the rated return loss is 10 dB or greater at 100 MHz for 1000 BASE-TX (the specification requires greater than or equal to 8 dB).
- Verify that the insertion loss is less than 1.0 dB at 100 kHz through 80 MHz for 100 BASETX.
- Verify that the insertion loss is less than 1.4 dB at 100 kHz through 100 MHz for 1000 BASET.
- Verify at least 30 dB of crosstalk isolation between adjacent channels (through 150 MHz).
- Verify high voltage isolation to 15000 Vrms
- Transmitter OCL should be greater than or equal to 350 μH with 8 mA DC bias. [& q ^5 T! U
4 {6 Z* v B4 g% {
# F* V3 g; P9 l2 v. V |
|