PWM Dimming Control ! Y( z5 D- b& Z' K3 u/ dThe PWM signal is connected to EN pin to adjust the feedback voltage (VFB) then LED current is also changed. The EN pin is built-in components of filter to regulate PWM signal become a DC voltage. The DC voltage is valid from 0.25V to 2.25V. The feedback voltage and LED current keep constant when the DC voltage is higher than 2.25V. The PWM signal is recommended above 10KHz.+ q. L/ {4 `/ f+ j9 C* [( C7 O
1 L0 ^5 v" H* q
VFB = VEN / 10, E6 G8 A- i U: i
7 V* b- k9 f+ p/ F . Z* ~! T) A3 n' R3 ^$ N短路掉 EN 上的 1K 電阻 R15 試試看！# C2 r4 y9 R( V
2 p& F3 ?' H) j+ C* J' T$ n + b* p7 g0 t( Z* Y. |0 K# M0 N, O* Y# ?- }
/1 
发表于 2016-11-9 19:19
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
发表于 2016-11-10 08:34
* Y. |0 K# M0 N, O* Y# ?- }
