EDA365欢迎您！
您需要 登录 才可以下载或查看，没有帐号？注册
x
本帖最后由 wjh1985 于 2011-5-23 10:19 编辑 6 K4 O9 p% u( ~% D' C8 X7 b
4 y& }8 b' J7 y6 {+ X: \2 T9 S
0 s% p8 ^6 i4 [9 b2 N8 m
如图：
" a a7 t- ?0 O+ X3 [4 A, o$ JRequired Value = 0 MIL Actual Value = 0 MIL 为什么还有DRC错误？？？？？？？？？？？？？？？？
! D9 h. I) C0 ?
1 S: G1 t2 J3 ?. @4 P/ P我把Shape和Route keepin的大小和相对位置改了又改，还是出现这两种错误。。。 | Shape to Route Keepin Spacing | Shape在Route Keepin之外 | | Shape to Route Keepout Spacing | Shape在Route Keepout之内 |
! N6 R" C8 X6 ]- j* |/ `. [# I) D+ M$ y% B. G, A, O
/ D, a& R$ _9 F1 x( G- K S
' J' h5 x$ J! W' \9 C8 d) q# C8 E* m& |1 g
某网站的说法如下，但我尝试了还是不行！ Y( R, p1 P% p
You sometimes get these kind of DRC's if you have been changing units (mm to mils etc) or changing board accuracry (number of decimal places). It also happens sometimes on translated designs. You could try reducing the number of decimal places to see if that helps. If it not too much pain you could also try re-creating the route keepin area using the z-copy command and also the planes shape (again using the z-copy command). This command allows you to copy the board outline contracting or expanding it by a specific amount to create another shape (keepin / keepout and etch planes).
: y. T" h; @1 O% Z9 I: D# M' \' I
: d" v1 @, T o1 j* O M- X- `, b
求高手指教~！！！！！！！我的PCB文件如下：
DA.rar
(31.74 KB, 下载次数: 32)
| 
/1 
发表于 2011-5-22 11:57
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主
