呵呵，不看help还不行，解决了！ * `& W% |; v) vThe part name. This property is required to use the Place 9 \ B, A; {5 R3 z; ~2 @+ a5 X2 iDatabase Part command. Only the part name is necessary if 1 X- Z5 v( B+ H) A/ P& G) x, w. ~+ wthe part is stored in the same directory as the custom- k5 t. Y1 y- S* r( r1 i4 Z: b
schematic part libraries (.OLB files) that you configure in" [3 L2 j7 e9 G
Capture. (See the OrCAD Capture User’s Guide for more 5 y, \# I6 D8 [+ {information about configuring part libraries.)
/1 
发表于 2010-8-21 20:23
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主