|
|
- p/ V2 T% ]' X. i1 U
不確定是不是這個問題造成的，但可以參考一下這些資料。
7 u+ S; F7 Y) d6 ]) @
9 [/ ?5 H( x3 z1 J1 t下面這段話是肥死卡好（Freescale）的技術文檔節錄下來的，講得一針見血、但內容較雜（ 不只討論這個問題），我給你另一篇 ATMEL 的技術文檔，它專門討論 MCU 的 Start-up Time，淺顯易懂、還有一些電路上的建議！. ]! ?1 |2 L5 q3 k
$ N( C. ^2 H q- @0 g$ Z9 SLong Start-Up Time& C3 w. c# K9 L# j" v
A long start-up time is usually a more common problem with low-frequency crystals, since they tend to start much more slowly than high-frequency crystals. One of the causes of a long start-up time is weak loop gain. Oscillator start-up times will also be affected by the rise time of the power supply. When the power supply has a sharp rise time, the crystal will experience an energy impulse that will usually make it start faster than it would using a power supply with a slow rise time.* M1 v8 A, L8 E$ u
8 y! K3 O) S0 v& {) r
3 W# W* C: g2 e* ]" x |
|
/1 
发表于 2015-6-24 20:29
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
发表于 2015-6-25 09:36
楼主
发表于 2015-6-26 08:42
