呵呵，不看help还不行，解决了！ / [7 C( A. y% ?7 N8 TThe part name. This property is required to use the Place . S2 n2 e2 |4 R& WDatabase Part command. Only the part name is necessary if 5 D* d, W0 F9 @the part is stored in the same directory as the custom" D3 c' }, Z- e% w5 x$ e# c
schematic part libraries (.OLB files) that you configure in 0 S1 p n6 o/ C gCapture. (See the OrCAD Capture User’s Guide for more % X, D5 b$ h& s5 \information about configuring part libraries.)
/1 
发表于 2010-8-21 20:23
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主