请教版主，如下D码，如何编写CAM350的".arl"模板（cr5000设计的）

1##### · 发表于 2013-3-1 16:15

EDA365欢迎您！

您需要登录才可以下载或查看，没有帐号？注册

x

# 0 - mm
# 1 - inch
# 2 - mil
# 3 - micron
#
Unit          : 0

#
# Aperture Table
#
#  "[Code]:[Type]/[Posi,Nega]:[Figure]:[Size Parameters]"
#
# Code          - Aperture Code
# Type          - 'F'(Flash),'S'(Stream),'P'(Polygon)
# Posi,Nega    - 'P'(Posi),'N'(Nega)
# Figure       - 'CI'(Circle),'SQ'(Square),
#                   'RE'(Rectangle),'DO'(Doughnut)
#                   'RT'(Round Thermal),'ST'(Square Thermal),
#                   'CU'(Custom Aperture)
# Size Parameter - Figure is 'CI' -> '0.1'
#                                     Circle Diameter (Radius x 2)
#                   Figure is 'SQ' -> '1.0'
#                                     Square Width
#                   Figure is 'RE' -> '2.0/1.0/30'
#                                     Rectangle Width,Height and Angle
#                   Figure is 'DO' -> '3.0/1.0'
#                                     Circle Diameter and Inner Diameter
#                   Figure is 'RT' -> '3.0/1.0/0.1/4/0'
#                                     Circle Diameter,Inner Diameter,
#                                     Slit Width,Slit Count and Start Angle
#                   Figure is 'ST' -> '3.0/1.0/0.1/4/0'
#                                     Square Width,Inner Square Width,
#                                     Slit Width,Slit Count and Start Angle
#                   Figure is 'CU' -> 'XXX/0'
#                                     Pad Name and Angle
#
ApertureTable 1 {
"D010:F/P:CI:0.08500"

"D193:F/P:CI:10.00000"
"D201:F/P:SQ:0.10000"

"D510:F/N:RT:1.00000/0.60000/0.30000/4/45"

"D560:F/N:RT:6.00000/5.20000/0.40000/4/45"
}