|
|
没有看到你12模块具体的情况，不好说。
* P* M8 _( i7 K# F# ^+ q& j* @从你的图看，12个模块已经OK啦。其它的可能不符合条件，请参考Help：' F: }5 _8 L* s# @3 X; U) y
2 The target components of copy destination must satisfy the following conditions: ; Y, L. o4 W5 ^1 w1 G. `0 i" H
) f; X" o9 b. ~7 F# ]5 @
n An unplaced component or off-board component
5 } N) d: x' }( U& n4 o) \2 {
1 }7 |$ R! v* z2 B% x% m nn A component having the same part name as that of an original component6 V2 O) _+ M0 k& B1 b* I: O7 T
2 \1 z6 S1 R3 { Z! A
n A component having the same pin connection as that of an original component6 ~& D/ A9 c' Y" f. Z
$ k S9 D+ r2 u& `
n A component without position lock.
2 j$ f2 N) A- P0 b' D
& W6 ]+ k4 |/ Pn When a component is locked in angle, its angle is the same as that of the original one.( ~! r3 t4 y" i) M1 ~
8 @) ]; f5 Q" ^, T0 p9 ~# Zn When a component is locked in placement, its placement side is the same as that of the original one.- {) n, d7 H9 Y
4 f8 Z2 [8 q+ G1 M* Y- G3 The original figures to be copied must satisfy the following conditions: 7 U' h6 E1 ?. o/ l. F
5 e C6 r0 H, |# ^" P/ R
n A figure on the layer which is set to visible.+ a) x1 E9 Y/ j ^/ y5 S
& c" k9 U1 C! l) C8 Q( G& _! v5 P
n A figure on the active layer when Reference Active Layer is set to on.
8 ]( `9 P3 w% l' s1 X/ h0 A( T" U" g0 D& a
n For vias, any layer among from-layer and to-layer of the via is the selected layer.# |) @0 I( R2 ^1 H8 \# \
|
|
/1 
发表于 2017-5-31 16:59
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主
发表于 2017-8-6 07:28
