Qusrtus2 11.0 时序仿真第1次出现错误

lvben5d

在QUARYUS2 ->TOOL->RUN EDA SIMULATION TOOL 后 运行ModelSim 6.5出现如下报错。希望高手指教。Q385157936
For example, ModelSim may display the following error message:
# ** Error: (vsim-19) Failed to access library 'work' at "work".
这个问题在网上收了下， 按照官网的说法如下：
To find the cause of and resolution to this error, use the following verror command at the ModelSim command prompt:verror 19;ModelSim returns the following message:# common Message # 19:
! S# J- e% s# v# The specified library could not be accessed at the specified location.
# Verify that the directory exists, that it contains the ModelSim library,
+ h. o+ K) v% ?5 ~# and that you have the correct permissions for accessing it.
& B2 y5 M' L5 l' o1 t( \# Also make sure that the _info file in the library has the correct
/ q+ `  K+ p9 s; v% k: H3 }# access permissions.
# This message might be followed by another message that gives more information
! J5 s& P, P5 D7 N8 m  W6 j. f: V# about the problem.
#
# The vlib command creates ModelSim libraries. The vmap command maps
2 X# f7 q4 T7 M# logical library names to physical library locations. Use the vmap
# command without arguments to find out how all of your libraries are
# mapped.
#
, n: ~( _" h" R0 K" E8 [1 I# One way this problem can occur is if the mapping for the library in
, b* ~# V* t' ]4 l% K3 x# your modelsim.ini file contains an environment variable that is not set
6 q, }# j# F4 ^: k) s7 e# in your environment.还是不懂如何解决。
, N, y. H' h' ?, F' s

lvben5d

已经解决问题，大家注意，安装QUARTUS10.0版本后，路径千万不要带空格和中文！避免出现一些意外。