Mechanical via split into Stacked via?

karpcb15

We proposed the stcakup to manufacturer is  4 layer stack up with laser vias from layer 1 to2 ,2 to3 and 3 to 4 , mechanical via from layer 1 to 4.

0 e: ^8 V7 T6 M' L but Manufacturer splitted the mechanical vias from layer 1 to 4 in to stacked vias My Question is why manufacturer changed mechanical via to stacked via? cost also increased increase while using stacked vias?
9 W- p- z  k, j' B" g
; L% L* i. O1 P. n# R


  S' K7 e, z  [& [  |# B
1 ?, |8 u, I, A* J3 Z8 i, y- y
- U1 J: p6 B5 g  }" e" H

gavinjzz

各位都是外国人么，装逼都说英语

karpcb15

oh..

tencome

那是因为钻孔时，孔尺寸小于100um时，必须使用激光钻孔。
而激光钻孔时，不能钻太厚的板子。    所以要分开钻。

钻孔尺寸大于等于100um时，就是用机械钻孔，就是一次性从第1层钻到第4层。

karpcb15

* V1 G. g) s8 C/ h谢谢