EDA365电子工程师网

标题: 【求助】关于.il文件可识别中文的思路 [打印本页]

作者: whh5118    时间: 2013-8-22 11:38
标题: 【求助】关于.il文件可识别中文的思路
本帖最后由 whh5118 于 2013-8-22 11:40 编辑

在il文件编写过程中,中文识别比较恶心。
比方说 这个语句:
KK = "测试" 是load()函数是无法识别的。
思路:
用infile(),outfile()函数
读取.il文件,然后找出中文的编码,
用printf("%L" ..)打印出来,其他字符用printf("%s" ..) 打印出来。
打印到临时文件,然后在通过load()导入。
下面是代码,第七行代码有疑惑,rexCompile()函数好头大啊。
  1. defun(loadchina (fileName @optional password)
  2.         let((chin enout list11 list12 list13)
  3.                 chin = infile(fileName)
  4.                 enout = outfile("tempfile.il")
  5.                 when(chin
  6.                         while(gets(w chin)
  7.                                 rexCompile("Ch2En\\(.+\\)")
  8.                                 if(rexExecute(w) then
  9.                                         list11 = rexSubstitute("\\0")
  10.                                         list12 = substring(list11 1 nindex(list11 ")"))
  11.                                         list13 = stringToSymbol(cadr(parseString(list12 "()")))
  12.                                         printf("%s" substring(w 1 nindex(w list12)-1))
  13.                                         printf("%L" list13)
  14.                                         printf("%s" substring(w nindex(w list12)+strlen(list12) strlen(w)))
  15.                                 else
  16.                                         printf("%s" w)
  17.                                 )
  18.                         )
  19.                         close(chin)
  20.                 )
  21.                 close(enout)
  22.                 if(password then
  23.                         load("tempfile.il" password)
  24.                 else
  25.                         load("tempfile.il")
  26.                 )
  27.                 axlTempFileRemove("tempfile.il")
  28.                 t
  29.         )
  30. )
复制代码





欢迎光临 EDA365电子工程师网 (https://bbs.elecnest.cn/) Powered by Discuz! X3.2