EMI PCB layout design checklist

may15

! m6 E& T0 m8 W7 N" `9 R

file:///C:/Users/F2159499/AppData/Local/Temp/artED06.tmpLAN

uthe length of the LAN signal traces should be kept as short as possible(<3000 mils), LAN chip/phy to be located near the connector

$ r) p" }$ ]( _1 [" C

uall traces are routed referencing to GND throughout the length

uall traces not to cross any GND or power VCC plane split (moat)

  }" e$ J$ g) x  }& a8 s' ?* k

u all LAN signal traces not to lie adjacent to any CLK traces

ucheck their unity of LAN differential pairs trace width and spacing

4 G6 a! e/ U% _0 j8 o' o

udifferential pair termination located on chip side and should be populated

8 b" c; b0 Q0 v' s5 d+ }2 w, c

  y" J# R+ N( r$ d( P2 P( q6 f

surken

七叶

:):):):):)

philips

thanks

eleven_ip

看不懂？！！