我在ORCAD里把网表建立好了,然后在PADSLAYOUT中导入网表的时候提示如果下错误: " y* d4 v4 S' j. u# c" S3 g - y& o0 Q8 r- O! YReading file -- C:\ORCAD\开关电路.asc( h: w' p$ f4 |0 E
*Unspecified or unsupported version of ASCII file 3 R4 u- h9 H+ h*PADS-PCB*3 H$ t$ W. W. S: X% b" M+ d
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal N11335/ r, f2 X8 J( p7 [" S" J
*Bad *CONNECTION* ascii data format, nets must contain more than one pin. Signal +5V; P) P/ K! E3 X
Warning: deleting signal N11335 A! V5 a6 ?! x2 h" X" A+ z
Warning: deleting signal +5V8 @" @) ^9 Q6 B4 {
**INPUT WARNINGS FOUND** : L: r1 M5 Z3 `请问各位高手这是为什么?怎么改啊!
/1 
发表于 2008-6-18 13:45
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
发表于 2008-6-18 16:38
楼主