各位大侠，本人在导PCB时，报以下错误，该如何解决啊？ : ?# D' {4 f, Y- C5 p“* Because the current design is in default layer mode and the decal is in increased layer mode, you cannot add decal "0805". Open Layer Setup dialog box and change the layer mode of the design to increased layers.”
/1 
发表于 2011-8-17 17:34
QQ好友和群
QQ空间
腾讯微博
腾讯朋友
微信
收藏
支持！
反对！
楼主